ASSESSMENT USING GIS AND SEDIMENT ROUTING OF THE PROPOSED REMOVAL OF BALLVILLE DAM,SANDUSKY RIVER,OHIO1

ABSTRACT: The proposed removal of Ballville Dam was assessed by (1) using a new Geographic Information Systems (GIS) based method for calculating reservoir sediment storage, (2) evaluating sediment properties and contamination from core data, and (3) assessing downstream impacts from sediment routing calculations. A 1903 (pre‐dam) map was manipulated using GIS to recreate the reservoir bathymetry at time of dam construction and used in combination with a detailed 1993 bathymetric survey to calculate sediment volumes and thickness. Reservoir sediment properties and geochemistry were determined from 14 sediment vibracores. Annual sedimentation rates varied from 1.7 to 4.3 g/cm²/yr based on Cesium‐137 (¹³⁷Cs) and Lead‐210 (²¹⁰Pb) geochronology and dated flood layers. The pore fluid geochemistry (Ba, Co, Cu, Mn) of four cores showed surficial enrichments in Cu, while Co and Mn show secondary peaks within the sediments. GIS calculations showed that a designed channel through the former reservoir able to accommodate the 10 percent Probable Maximum Flood (PMF) would require removing approximately 0.35 million m³ of sediment (27 percent of the reservoir fill), either by dredging at a cost of up to $6.3 million or by releasing fine grained sediment downstream. A sediment routing model was applied for the critical 6 km downstream using four cross sections. The sediment routing model predicts that, for flows exceeding minimum Mean Daily Flow (1924 to 1998 data), greater than 90 percent of this sediment would be transported through downstream reaches into Lake Erie (Sandusky Bay).     

CULTURAL EVOLUTION AND WATER MANAGEMENT IN THE SALINAS RIVER VALLEY1

ABSTRACT: This article reports the findings of a case study of a major California water management district's effort to change its management approach. The following key findings and factors have influenced the Salinas basin management plan (BMP) and its progress: (1) the Salinas Valley is an economy dominated by highly sophisticated irrigated agriculture dependent on ground water; (2) a persistent pattern of agricultural overdraft of ground water has hurt growers primarily in the north end of the valley via induced saline intrusion of irrigation wells; (3) a complex set of water institutions, property and water rights, and land lease practices offer little incentive for good stewardship of land and water; and (4) the BMP approach initially may have intensified tension among growers and between growers and other water user groups. Water rules and practices in the Salinas Valley and Monterey County have evolved through a long historical process of adaptations. Therefore, any significant changes in local water use practices need to be understood in terms of cultural change, that is, changes in deeply held values, beliefs, and assumptions. We believe the BMP and the MCWRA are succeeding when evaluated from this evolutionary perspective. The fact that both still exist relatively intact testifies that they are working, albeit slowly.     

A practical approach to steam‐enhanced dual‐phase extraction: A case study

This article presents the results of a pilot test that was conducted to determine the effectiveness of using steam‐enhanced dual‐phase extraction (DPE) at a former industrial site in New York. The pilot test proved that steam‐enhanced DPE was very effective at removing significant contaminant mass from the subsurface in a relatively short time period. Concentrations of volatile organic compounds and semivolatile organic compounds in the vapor stream and groundwater were successfully reduced, in some cases by orders of magnitude. Based on the results of the steam‐enhanced DPE pilot test, the final remedy for the site includes implementing this technology at selected areas as an alternative to DPE alone or other remedial alternatives, such as excavation or groundwater pump and treat. © 2003 Wiley Periodicals, Inc.     

Re‐evaluation of treatment approach for a site contaminated with Freon‐113 and 1,1,1‐trichloroethane

This study demonstrates a remedial approach for completing the remediation of an aquifer contaminated with 1,1,2‐trichlorotrifluoroethane (Freon‐113) and 1,1,1‐trichloroethane (TCA). In 1987, approximately 13,000 pounds of Freon‐113 were spilled from a tank at an industrial facility located in the state of New York. The groundwater remediation program consisted of an extraction system coupled with airstripping followed by natural attenuation of residual contaminants. In the first phase, five recovery wells and an airstripping tower were operational from April 1993 to August 1999. During this time period over 10,000 pounds of CFC‐13 and 200 pounds of TCA were removed from the groundwater and the contaminant concentrations decreased by several orders of magnitude. However, the efficiency of the remediation system to recover residual Freon and/or TCA reduced significantly. This was evidenced by: (1) low levels (< 10 ppb) of Freon and TCA captured in the extraction wells and (2) a slight increase of Freon and/or TCA in off‐site monitoring wells. A detailed study was conducted to evaluate the alternative for the second‐phase remediation. Results of a two‐year groundwater monitoring program indicated the contaminant plume to be stable with no significant increase or decrease in contaminant concentrations. Monitored geochemical parameters suggest that biodegradation does not influence the fate and transport of these contaminants, but other mechanisms of natural attenuation (primarily sorption and dilution) appear to control the fate and transport of these contaminants. The contaminants appear to be bound to the soil matrix (silty and clay units) with limited desorption as indicated by the solid phase analyses of contaminant concentrations. Results of fate and transport modeling indicated that contaminant concentrations would not exceed the action levels in the wells that showed a slight increase in contaminant concentrations and in the downgradient wells (sentinel) during the modeled timeframe of 30 years. This feasibility study for natural attenuation led to the termination of the extraction system and a transaction of the property, resulting in a significant financial benefit for the original site owner. © 2003 Wiley Periodicals, Inc.     

WATERSHED OPTIMIZATION OF AGRICULTURAL BEST MANAGEMENT PRACTICES: CONTINUOUS SIMULATION VERSUS DESIGN STORMS1

ABSTRACT: Nonpoint source (NPS) models and expert opinions are often used to prescribe best management practices (BMPs) for controlling NPS pollution. An optimization algorithm (e.g., a genetic algorithm, or GA) linked with a NPS model (e.g., Annualized AGricultural Nonpoint Source pollution model, or AnnAGNPS), can be used to more objectively prescribe BMPs and to optimize NPS pollution control measures by maximizing pollutant reduction and net monetary return from a watershed. Pollutant loads from design storms and annual loads from a continuous simulation can both be used for optimizing BMP schemes. However, which strategy results in a better solution (in terms of providing water quality protection) for a watershed is not clear. The specific objective of the study was to determine the differences in watershed pollutant loads, in an experimental watershed in Pennsylvania, resulting from optimization analyses performed using pollutant loads from a series of five 2‐yr 24‐hr storm events, a series of five 5‐yr 24‐hr storm events, and cumulative pollutant loads from a continuous simulation of five years of weather data. For each of these three different event alternatives, 100 near optimal solutions (BMP schemes) were generated. Sediment (Sed), sediment nitrogen (SedN), dissolved N (SolN), sediment organic carbon (SedOC), and sediment phosphorus (SedP) loads from a different five‐year period (an evaluation period) suggest that the optimal BMP schemes resulting from the use of annual cumulative pollutant loads from a continuous simulation of five years of weather data provide smaller cumulative NPS pollutant loads at the watershed outlet.     

Geographic and ontogenetic variation in the diet and daily ration of the bonnethead shark, <Emphasis Type="Italic">Sphyrna tiburo</Emphasis>, from the eastern Gulf of Mexico

To examine variation in diet and daily ration of the bonnethead shark, Sphyrna tiburo (Linnaeus 1758), animals were collected from three areas in the eastern Gulf of Mexico: northwest Florida (∼29°40′N, 85°13′W), Tampa Bay near Anclote Key (∼28°10′N, 82°42.5′W), and Florida Bay (∼24°50′N, 80°48′W) from March through September, 1998–2000. In each area, diet was assessed by life stage (young-of-the year, juveniles, and adults) and quantified using five indices: percent by number (%N), percent by weight (%W), frequency of occurrence (%O), index of relative importance expressed on a percent basis (%IRI), and %IRI based on diet category (%IRI_DC). Diet could not be assessed for young-of-the-year in Tampa Bay or Florida Bay owing to low sample size. Diet analysis showed an ontogenetic shift in northwest Florida. Young-of-the-year stomachs from northwest Florida (n = 68, 1 empty) contained a mix of seagrass and crustaceans while juvenile stomachs (n = 82, 0 empty) contained a mix of crabs and seagrass and adult stomachs (n = 39, 1 empty) contained almost exclusively crabs. Crabs made up the majority of both juvenile and adult diet in Tampa Bay (n = 79, 2 empty, and n = 88, 1 empty, respectively). Juvenile stomachs from Florida Bay (n = 72, 0 empty) contained seagrass and a mix of crustaceans while adult stomachs contained more shrimp and cephalopods (n = 82, 3 empty). Diets in northwest Florida and Tampa Bay were similar. The diet in Florida Bay was different from those in the other two areas, consisting of fewer crabs and more cephalopods and lobsters. Plant material was found in large quantities in all stomachs examined from all locations (>15 %IRI_DC in 6 of the 7 life stage-area combinations, >30 %IRI_DC in 4 of the 7 combinations, and 62 %IRI_DC in young-of-the-year diet in northwest Florida). Using species- and area-specific inputs, a bioenergetic model was constructed to estimate daily ration. Models were constructed under two scenarios: assuming plant material was and was not part of the diet. Overall, daily ration was significantly different by sex, life stage, and region. The bioenergetic model predicted increasing daily ration with decreasing latitude and decreasing daily ration with ontogeny regardless of the inclusion or exclusion of plant material. These results provide evidence that bonnetheads continuously exposed to warmer temperatures have elevated metabolism and require additional energy consumption to maintain growth and reproduction. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Accumulation patterns of organochlorines in juveniles of Arctocephalus australis found stranded along the coast of Southern Brazil

The present study was conducted to elucidate the specific distributions of organochlorine (OC) compounds in various tissues and organs of juveniles of the South American fur seal (Arctocephalus australis) found stranded on beaches in southern Brazil. The OC residue concentrations occurred in the following order: PCBs>DDTs>CHLs>HCHs>HCB. OC concentrations in blubber were higher than other tissues (e.g. PCBs, 2480 ng g(-1) wet weight; DDTs, 660 ng g(-1) wet weight) indicating a positive association with lipid content (except for HCB). However, the poor nutritional status of these animals, possibly following a starvation period, is likely to have allowed the remobilization of organochlorines stored in lipids to other tissues throughout the body, increasing their vulnerability to toxic effects and possibly affecting their survival capability.     

The effects of a mandatory motorcycle helmet law on helmet use and injury patterns among motorcyclist fatalities

BACKGROUND: The National Highway Traffic Safety Administration (NHTSA) has found that motorcycle helmets are 37% effective in preventing death and 65% effective in preventing brain injuries in a crash. Unfortunately, in 1995 Congress lifted federal sanctions against states without helmet laws and since then there have been a number of primary motorcycle helmet laws repealed or weakened. More lives could be saved and serious injuries avoided if there was increased helmet use throughout the United States. METHODS: This study analyzed helmet use and injury patterns among motorcycle riders in the United States involved in fatal crashes from 1995 through 2003 and compared the results between states with and without a primary helmet law. Age, sex, injury severity and helmet use are some of the variables obtained from the Fatality Analysis Reporting System (FARS). RESULTS: In the 20 states and the District of Columbia, which currently have a primary helmet law, 84.0% of fatally injured riders were wearing a helmet. In the 27 states with a secondary helmet law, 36.2% of fatalities used a helmet, and in the remaining three states with no law at all, helmet use dropped to 17.6%. In the two states (Arkansas and Texas) that changed from a primary helmet law to a secondary helmet law in 1997, helmet use decreased from 78.2% in 1996 to 31.7% in 2000. CONCLUSION: If all states were to enact a primary motorcycle helmet law, helmet use would dramatically increase while decreasing the number of motorcyclist head injuries and fatalities. IMPACT ON INDUSTRY: The results of this study will hopefully persuade law makers to enact primary helmet laws in all states throughout the nation. Helmet manufacturers can use this data to design more comfortable helmets while also improving upon the protective qualities of these safety devices.     

The roles of garment design and scene complexity in the daytime conspicuity of high-visibility safety apparel

INTRODUCTION: This study examines the effects of high-visibility garment design on daytime pedestrian conspicuity in work zones. Factors assessed were garment color, amount of background material, pedestrian arm motion, scene complexity, and driver age. METHOD: The study was conducted in naturalistic conditions on public roads in real traffic. Drivers drove two passes on a 31-km route and indicated when they detected pedestrians outfitted in the fluorescent garments. The locations of the vehicle and the pedestrian were recorded. RESULTS: Detection distances between fluorescent yellow-green and fluorescent red-orange garments were not significantly different, nor were there any significant two-way interactions involving garment color. Pedestrians were detected at longer distances in lower complexity scenes. Arm motion significantly increased detection distances for pedestrians wearing a Class 2 vest, but had little added benefit on detection distances for pedestrians wearing a Class 2 jacket. DISCUSSION: Daytime detection distances for pedestrians wearing Class 2 or Class 3 garments are longest when the complexity of the surround is low. The more background information a driver has to search through, the longer it is likely to take the driver to locate a pedestrian--even when wearing a high-visibility garment. IMPACT ON INDUSTRY: These findings will provide information to safety garment manufacturers about characteristics of high-visibility safety garments which make them effective for daytime use.